CONTINUOUS FLESHING MACHINE “SP” MOD FOR PELT AND HAIR HIDES

A new hydraulic power pack, and an electronic control of the conveying speeds.

Continuous fleshing allows to reach a very high productivity. With the fleshing technology developed by CM Persico during its 50 years of experience in the tanning sector, the quality of fleshing is at the highest achievable levels.

The leather is introduced from the part of the head into the upper part of the machine, with the operator’s command the fleshing bench is closed and the leather enters the machine; in this phase the tail is stripped. The operator monitors the progress of the operation and, at the right moment, the fleshing of the second half of the skin, the part of the neck starts with a control. At this point as fleshing continues, the leather is released from the exit belt at the front of the fleshing machine with the grain facing upwards and the tail in front.

DATA SHEET
mkt_6616_800x550

Electrowelded and painted steel frame with the best technologies available on the market to avoid any type of corrosion over time.

mkt_6609_800x550

All machines are tested in every functionality before shipment.

gruppo-coclee-per-carniccio-2

Group of augers for the transposed flesh

Installed in front of the fleshing rollers and is composed of two stainless steel hoppers containing two augers that rotate conveying the flesh into the hopper of the flesh pump.
A very reliable technology that, unlike traditional systems, does not use water to transport flesh.

schienale_2

High efficiency pneumatic fleshing benches

The great dedication of our technicians has allowed us to develop and test new fleshing systems over the years. For some years the SP fleshing machines have been equipped with pneumatic fleshing benches thus guaranteeing excellent hide cleaning.

How does it work

funzionamento_fase1

Phase 1

 

Insert the hide from the head. The hide is transported inside the machine and the rear part, the tail side, is fleshed.

funzionamento_fase2

Phase 2

 

The leather descends into the lower transport rollers until the operator sees the beginning of the fleshy part go by through the mirror.

funzionamento_fase3

Phase 3

 

Lower transport roller closure.

funzionamento_fase4

Phase 4

 

Opening of the swinging bench in the upper part and closing in the lower part.
Starting the fleshing in the lower part of the machine to flesh the second half of the hide, the part of the head.
With this, the fully processed hide comes out of the front of the machine on the exit belt with the tail in front and the grain side facing upwards.

Optional

4

Raises for base

Hot galvanised steel risers are supplied on request for the installation of the fleshing machine at a height of 1.2m.
The risers include protections and gate with safety microswitch for maintenance.

3

Maintenance footboards

Optional support to the work platform is supplied on request when the machine is raised off the ground to allow ordinary operations such as sharpening and greasing in complete safety.